ARTICLE 9. RENEWABLE PARALLEL GENERATION ELECTRIC RATE SCHEDULE
15-901 Availability Limitations on System.
Service is available under this Rider at points on the Utility’s existing electric distribution system for Customers operating Renewable Energy Resources. The service is available to Customer-generators on a first-come, first-served basis until the total rated generating capability of all interconnections served under Parallel Generation equals or exceeds four percent of the City’s peak load for the previous calendar year. Upon reaching this limit, no additional service shall be available under this Rate Schedule. This Rate Schedule shall not be available for any electric service schedule allowing for resale.
(Ord. 1038)
15-902 Application.
(Ord. 1038)
15-903 Character of Service.
Single phase, 60 Hertz, alternating current will be supplied at standard voltages as available through one transformer. A qualifying Customer is a customer in good standing, connected to the Utility Electric Distribution System for the purpose of receiving retail electric service that also owns and operates a Generation Facility as defined in the Interconnection Standards for Installation and Parallel Operation of Customer-owned Renewable Electric Generation Facilities. The Generation Facility shall be installed and operated in accordance with the requirements of said Interconnection Standards.
(Ord. 1038)
15-904 Rates:
In addition to the rates set in Article 3 of Chapter 15 of the Code of the City of Chapman for Commercial and Residential Customers, all interconnected Parallel Generation Shall be billed monthly a Capacity Charge based off the System Nameplate Capacity Rating. The Capacity Charge shall be calculated using the following formula.
System Nameplate Capacity Rating (kW) x $ 0 = Capacity Charge
(Ord. 1038)
15-905 Minimum Bill.
The minimum monthly charge set forth in Article 3 of Chapter 15 of the Code of the City of Chapman plus the Capacity Charge shall be the minimum bill. Any credits ($) applied to the bill will not result in a total bill less than the Minimum Bill.
(Ord. 1038)
15-906 Metering.
Metering shall be accomplished by use of a Utility-approved electric meter or meters capable of registering the flow of electricity in each direction. The Utility may, at its own expense and with written consent of the Customer, install one or more additional meters to monitor the flow of electricity.
(Ord. 1038)
15-907 Customer Billing.
The measurement of net electricity supplied by the Electric Utility and delivered to the Electric Utility shall be calculated in the following manner. Electric Utility shall measure the amount of electricity delivered by Electric Utility to Customer and the amount of electricity generated by the Customer and delivered to Electric Utility during the billing period, in accordance with normal metering practices. The kWh delivered by Electric Utility to the Customer shall be billed to the Customer at the rates contained in Article 3 of Chapter 15 of the Code of the City of Chapman. The kWh generated by the Customer and delivered to the Electric Utility shall be credited as described in Customer Billing Credit below. The calculated credit ($) applied to the bill will not result in a total bill less than the Minimum Bill.
(Ord. 1038)
15-908 Customer Billing Credit.
The billing credit for surplus energy generated by the Generation Facility and delivered to the Electric Distribution System that exceeds the Customer’s instantaneous load but is not in excess of the appropriate generator size, the City shall credit one hundred and fifty percent (150%) of the City’s actual cost of purchased energy ($/kWh) for the periods in which energy was delivered to the City.
(Ord. 1038)
15-909 Terms and Conditions:
(Ord. 1038)